Spa Cover Stands & HOLDERS
Cover Stand
If you've got a light cover and don't really need a cover lifter, this convenient stand will help to keep your cover clean and off the ground.
Measurements: 18" Wide, 24" High, 12" Deep (46cm x 61cm x 30.5cm)
Folds Flat when not in use.
£
Cover Shelf
The CoverShelf is:
Economical - If space behind your hot tub is not a factor this is the most affordable way to easily remove and store your cover.
Practical - It eliminates any obstruction of your view cause by the stored cover.
Simple - Swing it into the open position, then simply slide your cover onto the shelf.
Smart - The CoverShelf tucks out of the way when not in use.
The CoverShelf mounts to the side of your spa
and comprises brackets, screws and support tubes to fit any
square or oblong hot tub up to 8 ft (2.44 m) wide.
Made of strong, weather-resistant plastic and steel to provide years of trouble free performance.
Rear clearance required: 1/2 cover length.
Side clearance required: None
£
Cover Catch
The CoverCatch is the perfect answer for keeping your cover
close by and off the ground. Install the arms low on the spa for
an unobstructed view, or higher up for added privacy.
Black powdercoated, rust-free construction.
Arms fold flat against the spa when not in use.
Five minute installation.
Requires only 10" of clearance behind the spa.
Works well on all smaller spas regardless of shape.
Foam rubber pads provide a soft, slip-free surface
for the cover to rest on.
The Cover Catch is the smart way to remove and store your cover safely and out of the way.
£
08454 300 030
(Local rate)
Hot Tub Servicing
Maintenance
Spares & Repairs
- Lifters - Under Mount
- Lifters - Side Mount
- Cover Stands
- Cover Straps & Locks
- Replacement Covers
- Spa Cover Lifter Comparison Table
Cover Lifters
